Wide Input SHIM review

Wide Input SHIM review

The Wide Input SHIM from Pimoroni is a handy board that widens the range of power sources you can use with a Raspberry Pi. The bare Raspberry Pi board is very particular about its power source. It likes a 5.1 V micro USB power supply – the kind commonly used by smartphones. This article first appeared in The MagPi 69 and was written by Lucy Hattersley This 5.1 V requirement is enough to power the board, most HATs, and even the occasional servo. But what if you want to integrate the Raspberry Pi within a larger project with different voltage requirements? That’s where the Wide Input SHIM steps in. With it you can use a range of power supplies, from 3–16 V. These are converted by the small board to 5 V with 2 A output thanks to a TPS63070 buck-boost converter chip. Measuring just 45×17×6 mm (L×W×H), the SHIM tucks neatly into the corner of the Raspberry Pi board and takes up the first 12 of the 20 GPIO pins. It’s also super-skinny, at just 0.8 mm thick. Connection options You can solder the board to the supplied female header and pop it to the end of the GPIO pins. Or, if you’re feeling adventurous, you can solder the board directly to the GPIO pins on your Raspberry Pi. It’s not a soldering project for the faint of heart (or wobbly of hand). The board features a 3.5 mm barrel jack connector, and included in the package is a 5.5 mm adapter cable. There are additional + and – pins on the SHIM so you can wire up power directly. Or you can use the 3.5 mm to connect black and red tinned wires to integrate the SHIM with your project or hook it up to a bench power supply. Next to the + and – pins is an EN pin. Pulling this to ground will cut the 5 V voltage output. Be warned though that it won’t perform a clean shutdown. There is also a distinct lack of an on/off button on the board. We would have liked to have seen the button and safe shutdown script from the OnOff SHIM. Last word 4/5 A perfectly good product that lets you use a wider range of power inputs in your project. It’s fiddly to solder directly onto the board, but the supplied female header makes for an easier solder project. We would have liked an on/off switch, though. The…
Source: Wide Input SHIM review

답글 남기기

이메일은 공개되지 않습니다. 필수 입력창은 * 로 표시되어 있습니다.